How to record and assign a macro on my MonsGeek keyboard using MonsGeek driver?

---

Follow these steps to create and assign a macro in the MonsGeek driver:

1. Open the driver software and go to the Macro interface.
2. On the left panel, click the plus (+) button to create a new macro.
3. Select the new macro from the list and click Record on the right side.
4. Press the keys you want to record. The driver will capture the key sequence and timing (note: special keys like Fn are not recorded).
5. Click Stop Record when finished, then click Save.
6. To adjust timing, select individual keypresses and input a number to set a time interval between press and release. You can also use Fixed (1)ms to set a fixed time before you record the macro.

Once your macro is ready, you can assign it to a key and choose a trigger mode:

• LOOP (N): The macro will repeat N times automatically (default is 1).
• Assign Macro to Selected Key: The key works as a toggle — press once to start, and again to stop.
• Press to Play: The macro runs only while the key is held down.